2009-05-06
A few more hours in the shop and a bit more progress. For the most part, I did a lot of sanding and rasping and more sanding and then I sanded some more. For a "quick and simple" cookie tin banjo, this sure is taking quite a long time.

The first thing that needed to be done was the creation of the last tuning peg. Since all of the pegs are quite unique in shape, I decided to etch numbers in the peg face so that it would be easier to keep track of which peg should go where when I taper the tuning pegs holes in the neck.


Where the potrod was glued to the neck, I rasped and sanded to get the shape just the way I wanted it. After the neck and potrod was shaped, I sanded with various grits to get the neck as smooth as possible.


The tails were trimmed off of the tuning pegs and the corners where rounded with a rough grit sand paper. At this point, I simply had to see what the finished banjer would look like with my new cookie tin banjo pot. Since the potrod is quite a bit longer than the diameter of the tin, in the future I will probably make a wooden banjo pot with a drum head. It could be a neverending project.

Next up (in theory): fret dot inlays, cutting the pot to fit the potrod, crafting the nut and bridge, figuring out the tailpiece/saddle.
Comments
Name:
not required
Email:
not required (will not be displayed)
Website:
not required (will link your name to your site)
Comment:
required
Please do not post HTML code or bbcode unless you want it to show up as code in your post. (or if you are a blog spammer, in which case, you probably aren't reading this anyway).
Prove you are human by solving a math problem! I'm sorry, but due to an increase of blog spam, I've had to implement a CAPTCHA.
Problem:
6 plus 9
Answer:
required
subscribe
 
2019
2016
2015
2014
2013
2012
2011
2010
December
November
October
September
August
July
June
May
April
March
February
January
2009
December
November
October
September
August
July
June
May
April
March
February
January
2008